Thingiverse
2 inch PVC Union Plug
von Tsaman01
1
Downloads
3
Likes
0
Makes
This is a plug intended to be used for winterizing pool equipment.
When I remove my chlorine generator and pump at the end of the year, I always have to plug or cover the pipes for the winter.
Getting tired of using duct tape and plastic, I whipped this up!
The only thing I had to do for mine was to round the edges of the thread and interior circle - it was REALLY tight but a couple of minutes knocking the high points off with a file made it screw in just fine!
Note - this is not for pressurized applications - its just to close off open pipes to keep critters out!
Hope it helps someone!
When I remove my chlorine generator and pump at the end of the year, I always have to plug or cover the pipes for the winter.
Getting tired of using duct tape and plastic, I whipped this up!
The only thing I had to do for mine was to round the edges of the thread and interior circle - it was REALLY tight but a couple of minutes knocking the high points off with a file made it screw in just fine!
Note - this is not for pressurized applications - its just to close off open pipes to keep critters out!
Hope it helps someone!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!