MakerWorld
Test Models
Zum Modell
.2 Nozzle Filament Flow Test
514
Downloads
61
Likes
169
Makes
I print a lot of small things and I've had more than one print over extrude and get knocked off the bed mid-print. The built in filament calibration doesn't work well for a .2 nozzle especially when failure can affect the otherwise good tests. This model uses print by object and tests 9 different flow rates, starting with .64 and going to .96 in .04 increments. You don't need to examine the final print and see which one looks the best then do math to find out the flow rate. Each test rectangle comes with a custom filament profile with the final flow rate already listed. You can run all 9 tests at once or copy a few squares to a new plate to quickly test a few. Each test item is only a few layers thick, enough to find out if the flow rate is too high and if the end result is going to have defects which would lead to the nozzle scraping it off. After you run the test, if all the tests stuck to the bed, congratulations, the basic profile is good enough. If one or more fail, lo
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!