Thingiverse
2" Sanding Drum
von CoelacanthsKill
21
Downloads
13
Likes
0
Makes
The shaft hole is approx .315" in diameter and the drum OD is 2". I made this so a SBC pushrod can be hammered/pressed into the part, then a piece of cut sandpaper is to be wrapped around the drum. A slot was put in if you wanted to make the drum eccentric for larger diameter holes.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
