20 mm Golf peg

A simple 20 mm elevation golf peg modelled after a store-bought kind that I own.
The full length is 40 mm but it's designed to go 20mm into the tee, as ensured by the wide base.

It's best printed with the top facing down on the bed and in multiples to ensure adequate cooling on each peg in between layers, especially on the very tip.

I recommend PLA for the material as it's both relatively sturdy and also biodegradable (usually made from corn starch!) as many of you may know. So far I haven't had any issues with them but I'll always be carrying extra just in case I break a tip.

Please leave a comment if you have any recommendations, questions or concerns.

Happy Golfing!