Thingiverse
20 MM track switch
von ebwpob53
5
Downloads
7
Likes
0
Makes
The 20mm track switch will take an inbound marble (bearing) and send it off in 2 alternating directions.
The ball guide is used to direct the in-coming marble to the center of the switch.
The ball guide has a notch that the feeding track fits into, if you need the notch on the other side, mirror the guide in your slicer.
The ball guide is used to direct the in-coming marble to the center of the switch.
The ball guide has a notch that the feeding track fits into, if you need the notch on the other side, mirror the guide in your slicer.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!