drylin® bearing for 8 mm shafts; OD 16 mm

drylin® linear bearing from igus®

The so called RJMP-01-08 is a bearing made for linear movements.

It reaches similar wear-characteristics than the injection molded one, if you print it out of iglidur® tribo-filament.

The bearing should fit without rework? Then use one of the 3d-models with clearance; 0,3 mm clearance works best to get at the end a part with a very little clearance.

Dimensions:
ID = 08 mm
OD = 16 mm
B = 25 mm (length)

Check www.igus.eu/tribofilament for more