DIY Electric longboard (Battery & electronics enclosure)

This is a enclosure that I use on my DIY electric longboard. It is designed to host two Turnigy 3s 5000mah lipos as well as connectors for charger and a 2x3s to 6s balance connector board and a power switch board and switch. There are no pre drilled holes in the model making it easier to make cut outs and holes where its needed later.
The part is modeld to fit the radius of a Madrid Weezer 36” longboard.

The five splitted parts are printed one by one on my Wanhao Duplicator i3 V2 at 0.3mm l