Thingiverse
PrintrBot Play Extended Bed Mount 165mm!
by calviniba
11
Downloads
5
Likes
0
Makes
Extend the stock bed to 165mm!!!
These are printable diagonally on the stock bed. You can rotate the model without being constrained to 15 degree increments by pressing shift in cura. Also, decrease the skirt line count and distance. You can even change the bed dimension in cura to 102x102mm or whatever if you have to.
In cura, increase the bed dimension to 165mm in the y direction, and change the firmware to 165mm in the y direction through pronterface. I forget which command it is, but y
These are printable diagonally on the stock bed. You can rotate the model without being constrained to 15 degree increments by pressing shift in cura. Also, decrease the skirt line count and distance. You can even change the bed dimension in cura to 102x102mm or whatever if you have to.
In cura, increase the bed dimension to 165mm in the y direction, and change the firmware to 165mm in the y direction through pronterface. I forget which command it is, but y
Sign in to leave a comment
Sign in