E3d hotend mount for BFB 3D touch

This printable mount allows for a E3D hotend to be mounted to the existing BFB 3D touch carriage. I've been using this setup for over a year with the same printed parts with no problems. Very rigid.

Follow the 3D systems instructions for removing an old hotend:
http://www.3dsystems.com/shop/support/legacy/manuals

Required hardware:
3 x M3 x 15mm SHCS
3 x m3 nylon lock nuts
3 x m3 washers (I super glued the washers to the printed mount to make it easier to screw on).

I opted for re-u