Thingiverse
2015+ WRX AP Mount - BEEF
by jasonjones
146
Downloads
94
Likes
1
Makes
Not really a remix as I didn't use any of the original model itself, just used the thing for inspiration for my own version. Modeled from the ground up to be more robust.
This one is Beefier, less shake when on the road, doesn't require the use of the flimsy stock mount that was included and just seems to sag and not hold the AP very well at all. This one is a Fixed angle, but it is optimized to reduce the glare from your clothing when viewing the AP in sunlight, and stay below the hood line and out of the line of sight for traffic. Also clears your driverside vent so the AP is not getting blasted or blocking your air. Cord routes to the left side of the steering column.
Removed the whole bolt and nut bit replaced with using 3M double sided tape. You can get away without using tape at all and just glue some 2mm foam or cork to the inside of the clamp if you like. The clamp holds very good without tape.
Main clamp prints without any supports needed, all angles should overhang wi
This one is Beefier, less shake when on the road, doesn't require the use of the flimsy stock mount that was included and just seems to sag and not hold the AP very well at all. This one is a Fixed angle, but it is optimized to reduce the glare from your clothing when viewing the AP in sunlight, and stay below the hood line and out of the line of sight for traffic. Also clears your driverside vent so the AP is not getting blasted or blocking your air. Cord routes to the left side of the steering column.
Removed the whole bolt and nut bit replaced with using 3M double sided tape. You can get away without using tape at all and just glue some 2mm foam or cork to the inside of the clamp if you like. The clamp holds very good without tape.
Main clamp prints without any supports needed, all angles should overhang wi
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
