Thingiverse
2015 wrx shifter stop
door samako
46
Downloads
34
Likes
1
Makes
Helps reduce the slop of the shifter in the 1st and 2nd gear channel.
Should be printed with ABS or TPU ( at least 60D hardness), at 100% infill for strength.
You'll need 2 M6x16mm bolts or cap screws and maybe a couple locking washers to hold it in place. The original bolts are too short to hold both pieces.
Should be printed with ABS or TPU ( at least 60D hardness), at 100% infill for strength.
You'll need 2 M6x16mm bolts or cap screws and maybe a couple locking washers to hold it in place. The original bolts are too short to hold both pieces.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!