Thingiverse
2016 Ghostbusters Reboot Pack Inside Dome Structure GB16
by Spongeface
92
Downloads
51
Likes
0
Makes
This is an original design and is not very movie prop accurate - I just made something that I liked!
Print out 5 pieces and then use wire or filament to align through the provided holes and glue together. Then sand, sand and more sanding. Paint and then when done you get to add all of the fun components.
The center support has a slot for an Adafruit 60 LED light ring that is built of 4 quater round sections. It will not fit in through the openings if completed, so I left the last connection unsoldered and corkscrewed it up through the bottom. Then finished the couple of solder joints to join the ring togethr inside the structure. Yes it was a bit cumbersome...
I also mounted a speaker and it sets on the small flat inside lip on the bottom. It is a Dayton Audio PA130-8 5" Full Range PA Driver, 8 ohms so matches the sound boards I have.
Print out 5 pieces and then use wire or filament to align through the provided holes and glue together. Then sand, sand and more sanding. Paint and then when done you get to add all of the fun components.
The center support has a slot for an Adafruit 60 LED light ring that is built of 4 quater round sections. It will not fit in through the openings if completed, so I left the last connection unsoldered and corkscrewed it up through the bottom. Then finished the couple of solder joints to join the ring togethr inside the structure. Yes it was a bit cumbersome...
I also mounted a speaker and it sets on the small flat inside lip on the bottom. It is a Dayton Audio PA130-8 5" Full Range PA Driver, 8 ohms so matches the sound boards I have.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!