Thingiverse
2018 TEVO Flash Leveling knob
door SQMoose
9
Downloads
5
Likes
1
Makes
Fat Fingers Unite !
This will fit over your current 16mm Burl Nuts on the leveling carriage. It gives you about 3 mm clearance on your Y axis belt drive.
I tried other files up on Thingiverse that were listed but they were all too big, and I believe designed for flat carriages. The new Flash has a stepped carriage with a limited field for the adjusters.
This was a tight fit on the nuts themselves, so I used a rubber mallet to set the nuts into the PLA. Once installed on the printer, what a difference it makes when leveling.
I hope other anyone needing relief from the grief of manually leveling gets some use out of these.
This will fit over your current 16mm Burl Nuts on the leveling carriage. It gives you about 3 mm clearance on your Y axis belt drive.
I tried other files up on Thingiverse that were listed but they were all too big, and I believe designed for flat carriages. The new Flash has a stepped carriage with a limited field for the adjusters.
This was a tight fit on the nuts themselves, so I used a rubber mallet to set the nuts into the PLA. Once installed on the printer, what a difference it makes when leveling.
I hope other anyone needing relief from the grief of manually leveling gets some use out of these.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
