Thingiverse
2020 Corner Bracket (extra beefy)
von abrokadabra
1.1k
Downloads
622
Likes
0
Makes
A remix of a quality bracket found on thingiverse.
It was scaled up 2.5%, and inner groves reduced. Proven to tightly fit Misumi 2020 #5 extrusions. If you want an even tighter fit, with a well-tuned printer you could print at 0.99 scale.
For use with M3 x 10mm bolts and M3 T-nuts. I also recommend using M4 washers on the side bolts - otherwise the bolts began to separate the vertical layers when tightened..
Recommend Print Settings:
2 layer shell, 1mm bottom/top, 30% infill.
Update: 9/15/15
Added v2. Now extends further down the Z axis, and the X/Y corner has been eliminated in order to attach cast aluminum braces in its place.
It was scaled up 2.5%, and inner groves reduced. Proven to tightly fit Misumi 2020 #5 extrusions. If you want an even tighter fit, with a well-tuned printer you could print at 0.99 scale.
For use with M3 x 10mm bolts and M3 T-nuts. I also recommend using M4 washers on the side bolts - otherwise the bolts began to separate the vertical layers when tightened..
Recommend Print Settings:
2 layer shell, 1mm bottom/top, 30% infill.
Update: 9/15/15
Added v2. Now extends further down the Z axis, and the X/Y corner has been eliminated in order to attach cast aluminum braces in its place.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
