Thingiverse
2020 Corner Bracket, no screws needed
door jpnurro
30
Downloads
20
Likes
0
Makes
Corner bracket for 2020 V-slot profile. No disassembly of the frame, nor T-nut or screws needed.
Place the bigger half on the slot and slide the smaller ones in via profile. The locking bar goes over the smaller ones and will lock with the bigger one.
Bar is better to print vertically to achieve the maximum strength.
If the bracket feels loose adjust the 1st layer a bit higher.
Place the bigger half on the slot and slide the smaller ones in via profile. The locking bar goes over the smaller ones and will lock with the bigger one.
Bar is better to print vertically to achieve the maximum strength.
If the bracket feels loose adjust the 1st layer a bit higher.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
