Thingiverse
2020 Filament Guide
door Evan_VW
1.1k
Downloads
650
Likes
6
Makes
This is a little clip-on filament guide for the Folgertech FT-5 but it will work for any printer with 2020 aluminum extrusion rails. Simply snap it on and pass your filament through the guide! There are models with holes parallel and perpendicular to the extrusion. If your printer is not very precise, you may want to scale up this model 1%-2% to ensure it snaps on correctly, but make sure that it clips tightly enough to not slide.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
