Thingiverse
2020 mosfet mount
door Moederbeer
128
Downloads
90
Likes
0
Makes
###2020 mosfet mount
What is it?
---------------------
A simple carriage that mounts flush to a 2020 extrusion with two M5 screws. You can print the bushings to place inbetween the four M3x10mm screws that screw the board to the carriage. This will make sure the 10mm screws sit flush with the underside.
What is it?
---------------------
A simple carriage that mounts flush to a 2020 extrusion with two M5 screws. You can print the bushings to place inbetween the four M3x10mm screws that screw the board to the carriage. This will make sure the 10mm screws sit flush with the underside.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
