Thingiverse
2020 mount LED toggle switch enclosure mount ender
von RetroCare
1
Downloads
1
Likes
0
Makes
a simple mount for a toggle switch, I needed this to switch Off, Low and High for my LED bar so that its not over exposed, High (without resistor), Low with 330 Ohm resistor.
I found that High(full) is good for repairs, switching nozzles etc. but it overexposes for the cam.
I found that High(full) is good for repairs, switching nozzles etc. but it overexposes for the cam.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
