Thingiverse
2020 Stand
13
Downloads
10
Likes
0
Makes
I needed something to hold a length of 2020 while working on an extruder assembly.
This is what I got.
They're 60mm from the table to the bottom of the 2020.
Scale their Z if you want them taller/shorter.
Shown are in PLA+, 15% Infill, No support.
Orient on the print plate as shown.
This is what I got.
They're 60mm from the table to the bottom of the 2020.
Scale their Z if you want them taller/shorter.
Shown are in PLA+, 15% Infill, No support.
Orient on the print plate as shown.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
