Thingiverse
2020 Trinket Mount
von elemgee
10
Downloads
7
Likes
0
Makes
needed a 2020 mount for a Trinket 5V
(used to preprocess the FSR-signals for automatic bed-leveling in my Mini)
but didn't really like any of the ones around, so I made this.
the center hole is meant for a M4x8 maybe M4x10 and a drop in T-Nut.
the 4 holes for mounting the trinket are deliberately smaller, so you can use small wood screws or drill them to a diameter that suits.
I used a pair of stray M2.5s to mount the board and it's very secure.
(used to preprocess the FSR-signals for automatic bed-leveling in my Mini)
but didn't really like any of the ones around, so I made this.
the center hole is meant for a M4x8 maybe M4x10 and a drop in T-Nut.
the 4 holes for mounting the trinket are deliberately smaller, so you can use small wood screws or drill them to a diameter that suits.
I used a pair of stray M2.5s to mount the board and it's very secure.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
