2020 Webcam Stand

I needed a webcam mount that had some height adjustment...
I had some 2020 left from some project, so I made this to mount the webcam between my two monitors.

All the holes are for M5 thumb screws with 2020 nuts to attach to the extrusion.
You can tap and screw an M5 screw into the end of the extrusion to secure it to the base, or use Base 2+ to connect it from the back. I added a few variants in case you think the original is boring looking, although that's usually my target.

You need a short 1/4 20 screw to attach the webcam.

I added a T connector in case you are adding it to your printer for Octoprint