Thingiverse
USBasp-BAITE-Case
by OderWat
53
Downloads
48
Likes
3
Makes
#### The case is for a special USBasp (BAITE) which has a little dip switch for changing voltage!
The lid is meant to be printed in a translucent and the case in an opaque material. You need to glue them together after inserting the device. It should fit and after glueing it should not move inside anymore. Make sure your printer is calibrated very good!
You should choose supports for the front and back holes to print clean.
Note: You can partial cover the translucent area to focus the L
The lid is meant to be printed in a translucent and the case in an opaque material. You need to glue them together after inserting the device. It should fit and after glueing it should not move inside anymore. Make sure your printer is calibrated very good!
You should choose supports for the front and back holes to print clean.
Note: You can partial cover the translucent area to focus the L
Sign in to leave a comment
Sign in