FT-5 Filament Bracket

I made a bracket for my FT-5 printer that will hold a rod which will in turn hold a the spools of filament. This will mount on the top side rails, left and right of the FT-5 and is 150mm high so the spools should be in a perfect height, Mount one on each side center of tower at center of rail.

I made the mounting holes so you can use 4 of the leftover M5x10mm screws and T nuts from the build. Width of base is 220mm X 5mm thick and Height is 150mm

If you like it, Use it!

I will post som