Thingiverse
2022+ WRX Trunk Handle
von memeanlion
0
Downloads
1
Likes
0
Makes
Trunk handle that attaches to your trunk latch.
I used a M6-1.0 x 25mm square-shaped socket screw from home depot with a m6 flat washer to attach it after taking off OEM bolts.
Print in PETG or ABS.
Print with part lying on flat side, and support the rods. This will give maximum strength of the part.
I used a M6-1.0 x 25mm square-shaped socket screw from home depot with a m6 flat washer to attach it after taking off OEM bolts.
Print in PETG or ABS.
Print with part lying on flat side, and support the rods. This will give maximum strength of the part.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
