Lens Cap 52mm

I made this lens cap for my camera and because I'm very happy with this I will share it here. You can use ABS or PLA or others. Yiu have to print 2 parts ( Cap and Spring) and you need 2 M3 x 6mm screws. The spring has two little rips. to print this in a good quality you should set the layer hight to max. 0.15mm.

1) Print the parts
2) Drill the 2 bores in the spring to 2.5mm and cut a M3 threat in there.
3) Screw spring and cap together as shown on the pictures

Have fun

Peter