The Joyful yell no/minimal support

Do you love bendansie's masterpiece The Joyful Yell as much as I do? Do you hate removing support and the scars it leaves on great models as much as I do? If so, this may be the solution.

I carefully cut the original model (medium merged) into three pieces using Netfabb. The cuts are done such that 1) no support is needed 2) most critical part is printed at best quality 3) the seams are inconspicuous. I then did a 200% scaled up print at 0.08mm and in Hatchbox 720C PLA. Glueing is simple, alt