Thingiverse
FLsun 3d 165mm calibration beam
by psemeq
17
Downloads
3
Likes
0
Makes
It is highly recommended to use M4 nut with positioning as it will make whole printer stiffer:
http://www.thingiverse.com/thing:2026006
Use nuts above to tie down the beams and than tighten the gantry to the base using m4 nuts .You can use the beams to adjust the Z carriage afterwards.
http://www.thingiverse.com/thing:2026006
Use nuts above to tie down the beams and than tighten the gantry to the base using m4 nuts .You can use the beams to adjust the Z carriage afterwards.
Sign in to leave a comment
Sign in