Thingiverse
GoPro Session soft case for use with original mounting case - Flexible
by PrintFail
37
Downloads
31
Likes
1
Makes
After smashing my old GoPro on asphalt, i´ve designed this protective case to be used with the original mounting case.
Must use flexible filament and a very low infill for the desired effect. I´ve used 5% and honeycomb pattern with TPU filament.
The little "door covers" on the side should maintain the case in place.
EDIT: Just changed the "face" of the cover. The last one was too big and visible at "wide angle" shots.
Printed with "lens down" + supports.
Must use flexible filament and a very low infill for the desired effect. I´ve used 5% and honeycomb pattern with TPU filament.
The little "door covers" on the side should maintain the case in place.
EDIT: Just changed the "face" of the cover. The last one was too big and visible at "wide angle" shots.
Printed with "lens down" + supports.
Sign in to leave a comment
Sign in