PEX Wreath Stabilizer Clip

This is a piece to hold 3/4" PEX in a nice circle pattern to form a 4 layer wreath. The clip should just snap onto the PEX, and provide nice even spacing between the rings. It will still allow you to adjust the PEX to fine tune the circles. I recommend you print and use the STL that has the clip on its side, so you get a better circle to hold the PEX.

Inside the PEX, I have 48 LEDs/Meter 2811 Pixel Strips, controlled by a Raspberry Pi, running FPP (Falcon Pi Player).