Thingiverse
3KU K3000 DiiCooler Adapter Bracket and Duct
by PotatoX
16
Downloads
8
Likes
2
Makes
This is an adapter to connect a DiiCooler to a 3KU 3D printer.
http://www.thingiverse.com/thing:1025471
DiiiCooler_SHORT_Rev3-21.STL
The print consists of two pieces which can be joined together with glue, or a bit of acetone.
The clearance to the heater block and effector joints is tight so you will have to orient the mounting bracket and possible the heat block to achieve and acceptable fit.
In addition heat must also be considered. If you plan to print only PLA this may be printe
http://www.thingiverse.com/thing:1025471
DiiiCooler_SHORT_Rev3-21.STL
The print consists of two pieces which can be joined together with glue, or a bit of acetone.
The clearance to the heater block and effector joints is tight so you will have to orient the mounting bracket and possible the heat block to achieve and acceptable fit.
In addition heat must also be considered. If you plan to print only PLA this may be printe
Sign in to leave a comment
Sign in