2040 extrusion camera mount

I got tired of camera mounts that were either flimsy and kept vibrating, or camera mounts that did not have a good way to connect to the standard 1/4-20 nut that is used to attach to camera mounts.

this uses the standard:
1/4" x 20 bolt to connect to most commonly available webcams
M8 x 12 bolt + M8 t-slot nut to connect to the standard 20x40 or 40x40 rails used on most of these printers.

i've also included the STEP file so that you can remix as you see fit.

the wire slot was modified for easy printing, so it doesn't FULLY capture the wire, but does make a nice snug fit and should hold the wire, if you are very concerned, it's probably pretty easy to remix to add in slots for zip ties.