Anet A8 Spool Arm

Very simple but effective filament spool holder for the AnetA8 designed in Google SketchUp.
I suggest printing a spool cap for your spool so the spool doesn't wobble on the threaded bar.

Settings I used to print this.

PLA
Temp: 200 degrees
Thickness (Wall/Top/Bottom): 0.8mm
Layer Height: 0.3mm
Infill: 25%

I also created a 4mm brim but it's not needed I just have poor masking tape.


NOTE: The slot on one side is bigger than the other side the slightly longer one is for the threa