Thingiverse
Side-Mount Spray Can Holder
14
Downloads
9
Likes
0
Makes
Hairspray can holder for my Robo3D.
Used 3M tape to stick it to the side and it works great. Inside diameter of the holder is 3" so it should fit whatever can you want to put it.
Printed with PLA, 20% infill, no support (make sure you can bridge across the cup if you don't use support - I was impressed with my little ROBO!!)
Used 3M tape to stick it to the side and it works great. Inside diameter of the holder is 3" so it should fit whatever can you want to put it.
Printed with PLA, 20% infill, no support (make sure you can bridge across the cup if you don't use support - I was impressed with my little ROBO!!)
Sign in to leave a comment
Sign in