Thingiverse
Pergo 9 Volt Adapter Block
by Pergo
14
Downloads
8
Likes
0
Makes
In short, print, then drill the holes to make a good pilot hole for the screws.
Cut off the end of a 9 volt plug-in adapter and secure the stripped leads to the holes before putting the screws back in. It's best if you run the screws in and out a few times so that you don't cut the wires with the screw threads. Make sure you get your polarity correct. the + is the smaller male connector on the battery and the - is the female snap.
In most instances you may have to cut an exit path for the cabl
Cut off the end of a 9 volt plug-in adapter and secure the stripped leads to the holes before putting the screws back in. It's best if you run the screws in and out a few times so that you don't cut the wires with the screw threads. Make sure you get your polarity correct. the + is the smaller male connector on the battery and the - is the female snap.
In most instances you may have to cut an exit path for the cabl
Sign in to leave a comment
Sign in