Thingiverse
E3D V6 40mm Fan Duct Snap on with Zip tie tabs
by rich1051414
328
Downloads
164
Likes
3
Makes
Based on loco's E3d v6 40mm Fan Duct
I modified the model to be snap on, even in PLA, as well as adding zip tie tabs to be used either to more securely mount the fan duct, for wire management, or anything else.
Caution: I have yet to test how durable the PLA is over the course of time, but if I have problems, I will report back. However, even with the hot end facing towards the front, the shroud should not touch it, so direct melting shouldn't be an issue.
If the shroud fails to slid
I modified the model to be snap on, even in PLA, as well as adding zip tie tabs to be used either to more securely mount the fan duct, for wire management, or anything else.
Caution: I have yet to test how durable the PLA is over the course of time, but if I have problems, I will report back. However, even with the hot end facing towards the front, the shroud should not touch it, so direct melting shouldn't be an issue.
If the shroud fails to slid
Sign in to leave a comment
Sign in