Thingiverse
Arduino Stepper Peristaltic Pump utilizing 28YBJ-48 and ULN2003 based driver
by OpticDriver
53
Downloads
36
Likes
0
Makes
Arduino Stepper Peristaltic Pump utilizing 28YBJ-48 and ULN2003 based driver.
This is a work in progress, tried with fish tank airline and it was not soft enough. Will try again with proper peristaltic line.
At 5v, with fish tank airline, would not turn bearings, at 12v, it would run but the the motors ran very hot, and it did not produce any suction.... im hoping with some softer silicone tubing ill be able to run at 5v or slightly higher in order to keep the motors cool and produce the
This is a work in progress, tried with fish tank airline and it was not soft enough. Will try again with proper peristaltic line.
At 5v, with fish tank airline, would not turn bearings, at 12v, it would run but the the motors ran very hot, and it did not produce any suction.... im hoping with some softer silicone tubing ill be able to run at 5v or slightly higher in order to keep the motors cool and produce the
Sign in to leave a comment
Sign in