Thingiverse
Prusa I4 Fast Filament Change Lever
by Hectorem
26
Downloads
18
Likes
0
Makes
Februrary 2018
After a over half a year of use the front leg slid off, so I decided to thicken it up a little.
Probably won´t happen if you print at 100% anyway, but no reason to not fix it.
April 18, 2017
I just updated the model. The one I was using snapped after a few months, and I saw it was super thin on one end, so I thickened it up a little.
Still fits just as good. ;)
Have you ever wanted to change filament to continue a print or change filament color, but don't have the opti
After a over half a year of use the front leg slid off, so I decided to thicken it up a little.
Probably won´t happen if you print at 100% anyway, but no reason to not fix it.
April 18, 2017
I just updated the model. The one I was using snapped after a few months, and I saw it was super thin on one end, so I thickened it up a little.
Still fits just as good. ;)
Have you ever wanted to change filament to continue a print or change filament color, but don't have the opti
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in