Prusia I3 rework/clones extruder cable protector/tray - updated

UPDATE : Includes version 2 (ver 2 in the filenames). Differences are as follows :
1. 0.5mm shorter gap for the cable to snap in to. I had my cable pop out once following modification to my frame which extended my Z axis distance from 107mm to 207mm. I can print tall again!
2. Increased diameter of top most cylinder by 1mm to increase it's stength.
2. Widened base piece which sits directly on top of the frame. (Not side pieces.)
3. Made slightly longer, overall.

If Ver1 is working for