Geeetech G2S Top Stabilizer - On the Outside

Stabilizer for the Geeetech G2S Delta 3D Printer. It doesn't wobble as much after the top stabilizer and the bottom stabilizer mentioned below.

Print as in the 2nd picture (rotate 90 degrees on X, and -45 on Y).
I used 20% infill, 0.3mm PLA. Maybe I will try ABS some other day.
Also, I think Black will look better than magenta, so I will try that as well later.

Remixed from: http://www.thingiverse.com/thing:1912495
(Took the measurements for the vertical bars).
That one was installed