Thingiverse
3DR Richrap Fishline Idler (by Nakuta)
by stalkerface
27
Downloads
16
Likes
0
Makes
This Thingi is a Idler for the Richrap and also the JohnSL 3DR.
It Idles the Fishingline like Prusa X Belt Idler.
M4 Nut in the Top Nuttrap.
An M4 Screws through the Bearings with 2 Washers. It tightend with a Nut for the Aluextrusion.
The Second Screw (in the middle) clamps also with a Slotnut in the Extrusion. This must be tightend before idle. it must clamp alone without clamp in the idler. because the top idlerscrew lean on it.
Let these Screws a little bit loose before you t
It Idles the Fishingline like Prusa X Belt Idler.
M4 Nut in the Top Nuttrap.
An M4 Screws through the Bearings with 2 Washers. It tightend with a Nut for the Aluextrusion.
The Second Screw (in the middle) clamps also with a Slotnut in the Extrusion. This must be tightend before idle. it must clamp alone without clamp in the idler. because the top idlerscrew lean on it.
Let these Screws a little bit loose before you t
Sign in to leave a comment
Sign in