Thingiverse
20mm flight controller plate
von TomBu
10
Downloads
6
Likes
0
Makes
Just a simple flight controller plate.
Add on top of your stack to protect the flight controller or to have something to stick the receiver on to.
Hole spacing is 20mm x 20mm, edge to edge it is 24mm x 24mm x 1mm.
Add on top of your stack to protect the flight controller or to have something to stick the receiver on to.
Hole spacing is 20mm x 20mm, edge to edge it is 24mm x 24mm x 1mm.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
