Thingiverse
20x20mm Test Cube!
di TheManSteele
18
Download
11
Likes
0
Makes
Hello!
Here i have designed a simple test cube which can be used to calibrate your extruder and/or axis E-Steps!
It can be printed using less filament than some other test cubes
- The outer dimensions of the object are 20mm x 20mm x 20mm (L x W x H)
- Actual printed thickness of the walls should be 1mm as what corresponds to the 3D object. 1mm is approximately the thickness of two walls for a .4mm nozzle.
- As mentioned above, please use two walls for printing this to check wall adhesion
* The following formula can be applied to both flow rate and E-STEP calibration *
Calculations for calibration are as follows:
[(intended length)/(measured dimension)] x Current Value = New Value
Here i have designed a simple test cube which can be used to calibrate your extruder and/or axis E-Steps!
It can be printed using less filament than some other test cubes
- The outer dimensions of the object are 20mm x 20mm x 20mm (L x W x H)
- Actual printed thickness of the walls should be 1mm as what corresponds to the 3D object. 1mm is approximately the thickness of two walls for a .4mm nozzle.
- As mentioned above, please use two walls for printing this to check wall adhesion
* The following formula can be applied to both flow rate and E-STEP calibration *
Calculations for calibration are as follows:
[(intended length)/(measured dimension)] x Current Value = New Value
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
![The Ultimate Catapult, almost. [Seej]](/imgproxy.php?url=https%3A%2F%2Fcdn.thingiverse.com%2Frenders%2F11%2Fd8%2F4c%2Fcf%2F04%2Fultimatecatapult_thumb_medium.jpg&w=400&h=300)
