Thingiverse
21-cm Turntable
door t5montecarlo
13
Downloads
10
Likes
0
Makes
I designed this turntable to photograph items to sell. A matte filament works better than a glossy one, as it doesn't show off the layers as easily. I used Hatchbox True White PLA and Prusament Black PLA for the turntables pictured.
The turntable is an assembly of 4 parts.
The platter rotates on a bearing. There are parts that use a 608 bearing or a S1KDD bearing.
The bearing is intended to be a snug fit in the platter and less of a snug fit over the shaft, so the turntable can be easily disassembled.
The part that fits into the bearing was designed to be small so as to be easily reprinted if it breaks.
The turntable is an assembly of 4 parts.
The platter rotates on a bearing. There are parts that use a 608 bearing or a S1KDD bearing.
The bearing is intended to be a snug fit in the platter and less of a snug fit over the shaft, so the turntable can be easily disassembled.
The part that fits into the bearing was designed to be small so as to be easily reprinted if it breaks.
t5montecarlo publiceert ook op
12 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
