Spool holder for 2020 Extrusions (Deltas)

Spool holder for 2020 extrusion Delta. Will work for any 2020 frame but the spool holder comes off at a 30 degree angle to counter that of the delta frame.
*Note the M3 nut is very difficult to get on to the bolt given it is all the way inside the spool holder arm. I used a little superglue on the end of a sharpie (cap on) got it start then used a flat blade screw driver to tighten it up. I would have designed it better but was in a rush to get a spool holder for my build :) .
If you want the