Thingiverse
Heart Spongy
by LYTEHAUS
22
Downloads
23
Likes
0
Makes
Use version 009.
Import in mm. This is approximately 10cm across. Change the scale if you want.
Turn support material turned on.
I used 30° overhang threshhold and 0.5mm contact distance. You do NOT want a tight contact distance or you will never get to pick out all the little bits from inside the holes. I removed the support material with a brad awl and slim needle-nose pliers. It took me about an hour, but it was well worth it.
The picture is before processing. I trimmed the support mate
Import in mm. This is approximately 10cm across. Change the scale if you want.
Turn support material turned on.
I used 30° overhang threshhold and 0.5mm contact distance. You do NOT want a tight contact distance or you will never get to pick out all the little bits from inside the holes. I removed the support material with a brad awl and slim needle-nose pliers. It took me about an hour, but it was well worth it.
The picture is before processing. I trimmed the support mate
Sign in to leave a comment
Sign in