Thingiverse
Captain's Wheel Spinner
by eclipsefire
130
Downloads
116
Likes
1
Makes
**Uses 1 608ZZ Bearing. [Order from Amazon](http://amzn.to/2jZNTVo)**
Used OpenSCAD to design a captains wheel spinner.
For printing you'll want to take into account the dimensional accuracy as you want the bearings to be a tight fit. Scaling the model should help adjust to get a good fit, if it's a little loose you can use a bit of CA glue (superglue) to fix it in position. _Note: Be careful not to get any glue on the bearing as you could seize it up._
Be sure to share any comments an
Used OpenSCAD to design a captains wheel spinner.
For printing you'll want to take into account the dimensional accuracy as you want the bearings to be a tight fit. Scaling the model should help adjust to get a good fit, if it's a little loose you can use a bit of CA glue (superglue) to fix it in position. _Note: Be careful not to get any glue on the bearing as you could seize it up._
Be sure to share any comments an
Sign in to leave a comment
Sign in