Thingiverse
Back and forth thread
by dpruim
39
Downloads
27
Likes
0
Makes
A ring on a pin that goes back and forward when turned in one direction .. .
Video : https://youtu.be/lhfX5ZXipeo
If you are going to print this, you will have to make 4 parts, the middle, 2x the ring and the slider.
then glue the two rings together with the slider in it. . .
BE AWARE,, i did a lot of work afterwards, making the thread deeper, sanding down the slider a bit etc. . .
but i ended up with a nice toy ..
The openscad source is also there, you could make the
Video : https://youtu.be/lhfX5ZXipeo
If you are going to print this, you will have to make 4 parts, the middle, 2x the ring and the slider.
then glue the two rings together with the slider in it. . .
BE AWARE,, i did a lot of work afterwards, making the thread deeper, sanding down the slider a bit etc. . .
but i ended up with a nice toy ..
The openscad source is also there, you could make the
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in