Monoprice MP Select Mini Z-Axis Offset Clip For 1.75mm Glass

I had a piece of glass from a 5x7 picture frame that I wanted to use as a print bed. I didn't want to move the z-axis limit switch, so I printed this clip instead. It goes on the left-end of the x-axis gantry, and causes it to contact the limit switch sooner than it otherwise would. The thin end goes on the bottom.

After printing, I shimmed it out with painter's tape to fine-tune the height relative to the glass.

With glass, you will almost certainly need to use glue stick to get good adhe