Gingery Compound Slide

This is my take on the gingery Lathe Compound Slide. It is set up as a split pattern. You may have to sand it (depending on how good your printer is) in order to draw it. I used 320 grit sand paper to smooth out the edges and was able to cast the part. If you see pulling along the ware pads when you draw the pattern it is inside 1/4in part on the bottom that needs to be smoothed out with a slight draft (less than 1%). I used a scrap peace of wood 1"X1/4'X4" to do this. If there is any overhang i