Ikea Table Filament Guide with PTFE (Teflon)

Hi,

this is a Filament Guide for an Ikea Table. In this Guide there is an PTFE Inliner (you need about 4-5cm of PTFE (Teflon)Tube) which will be pushed into the 3D printed part afterwards.

You need to drill an 8mm hole through the top of the Ikea table. For best results please use a piece of tape on the top and on the back of the spot where you drill into the table to prevent the surface from shattering.

I hope you like it, if you have any questions fell free to ask.